User`s manual

24
3-3-3. WAN Connection Mode
After you have selected the ISP connection type in “WAN” and you want to modify the related settings, here you
can modify and configure the settings in details.
3-3-3-1. Virtual Dial-up (PPPoE)
Connection Mode : Show your current connection mode.
Account : Enter them provided by your ISP.
Password : Enter them provided by your ISP.
MTU : Maximum Transmission Unit. It is the size of largest datagram that can be sent over a
network. The default value is 1492. Do NOT modify it unless necessary. But if when
some specific website or web application software can not be open or enabled, have a
try to change the MTU value as 1450, 1400, etc.
Service Name : It is defined as a set of characteristics that are applied to a PPPoE connection. Enter it
if provided. Do NOT modify it unless necessary.
AC Name : Enter it if provided. Do NOT modify it unless necessary.
Connect Automatically : Connect automatically to the Internet after rebooting the system or connection
failure.
Connect Manually : Connect to the Internet by users manually.
Connect on Demand : Re-establish your connection to the Internet after the specific time (Max Idle Time).
Zero means your Internet connection at all time. Otherwise, enter the minutes to be
elapsed before you want to disconnect the Internet access.
Connect on Fixed Time : Connect to the Internet during the time you fix.
Note: The “Connect on Fixed Time” can be deployed only when you have set the current time in “Time
Settings” from “System Tools”.
3-3-3-2. Static IP
If your connection mode, static IP is chosen, you can modify the following addressing information.
IP Address : Here enter the WAN IP address provided by your ISP.
Subnet Mask : Enter the WAN Subnet Mask here.
Gateway : Enter the WAN Gateway here.
Primary DNS Server : Enter the Primary DNS server provided by your ISP.
Secondary DNS Server : Enter the secondary DNS.