Instruction manual

EN
19VS5013
ASSEMBLY
ATTENTION!
Pullthepowercordoutofthesocketbeforeassemblingordisassemblingtheunit.
The fan may only be used with the front and rear protective mesh attached (1), (5).
1.Usingparts(9,10),assemblethestandsupport.Usefourscrews(included)toattachthetelescopicsupport(7).
 Usetheplastichood(8)tocovertheconnection.
2.Mounttheunitbodyunitontothesupportstand,usexingscrew(15)toxtheassembly.
3. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the holes in the
mesh.
Usetheattachmentnut(4)tosecuretheassembly.
4.Slidethefan(3)ontothemotorshaftbypositioningthegroovesinthefanhubagainsttheshafttongues.
5. Turn the nut (2) counter-clockwise to fasten the fan.
6.Positionthefrontwiremeshontotherearmeshandslideonthefasteningring(14)sothat
themeshedgestintothegroovesontheinsideofthering.
7.Tightenthefasteningringwiththescrew.
OPERATING INSTRUCTIONS
Priortousingtheunitverifythepowercordisintact.
1. Placetheunitontheoorsecurelysoitcannottipover.
2. Uncoilthepowercord.
3. Tiltthefanasrequired(Fig.1).Youwillhearseveralclicksthatlockthefaninindividualpositions.
4. Adjustthedesiredheightofthefanbylooseningthestandnut(12)andextendingthetelescopicsupport(7)(Fig.2).
5. Connectthepowercordplugtothewallsocket.
6. Usethemodeselectortochoosetherequiredspeed–
0 – OFF, 1 – LOW, 2 – MEDIUM, 3 – HIGH.
7. Toturnfanoscillationowhiletheunitisrunning,pullouttheoscillationselector(Fig.3t).Pushingtheselectorinturns
oscillation on.
8.Afteruse,turnthemodeselectorto0andunplugtheunitfromthemains.
Fig.1 Fig.2 Fig.3