Instruction manual

EN
19RK0010, RK0011
OPERATING INSTRUCTIONS
1.Removethekettlefromthebase(6),openthelid(1),andlltheappliancewithcoldwaterwithinthepermitted
maximumonly.Ifthewaterlevelinthekettleisundertherecommendedminimum,thekettlewillkeepoverheating
andturningoprematurely.
Note:Makesurethatthelid(1)isclosedproperly,otherwisethekettlecannotturnoautomatically
2. Place the kettle on the base (6); electric contacts will get connected automatically. Thanks to the central connector
design, the kettle can turn around 360° and be put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (5).
Acontrol light on the switch (2) signals the kettle is in operation. The kettle lid (1) must be properly closed when water
is being heated.
WARNING!
 Donotopenthelidduringheatingorimmediatelyafterheatingiscompleted.Hotsteamcouldscaldyou!
5.Aftertheboilingpointhasbeenreached,thekettlewillturnoautomatically,andtheoperatinglightwillgoout.
Waterheatingcanbeterminatedprematurelybymovingtheswitch(5)totheoposition.
6.Removethekettlefromthebase(6)andusethehotwater.
7.Ifyouwanttoreheatthewateryouhavejustnishedboiling,waitforapproximately30secondsbeforereactivating
the switch (5).
Note:Itisnotasignofadefectwhenasmallamountofwaterdropletsappearonthekettlebase(6).Itisasmallamount
of condensed steam, which deactivates the kettle thermostat.
CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it
out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
CLEANING AND MAINTENANCE
Warning!
Prior to each cleaning operation disconnect the lead-in cable of the appliance from el.
socket!
Priortostartanyhandlingoperation,makesurethattheapplianceiscooleddown!
Use only a wet rag for cleaning surface of the appliance, do not use any cleansers or
hardthingswhichcoulddamagethesurface!
Never clean the appliance under running water, never flush it and never immerse
the appliance into water!
Scale removal
During common use water impurities are deposited. Use commercially available agents
for scale removal (observe manufacturer’s instructions).
Note:Removethedepositsregularly,onceaweekasarule-periodicitydependson
waterhardness and on frequency of kettle use.The deposits reduce eciency and
service life of the appliance materially.
Lack of maintenance can cause appliance‘s seal or heating element damage.
Defects caused by lack of maintenance are not covered by warranty.