User Guide

45
EN
OPP1060
Cleaning and replacement of lters
Textile grease lter
• This lter cannot be washed or otherwise cleaned.
• During normal use of the appliance, the textile grease lter should
be replaced every 2-3 months. Shorten this interval if you fry or fry
more often.
• Do not use the appliance without the textile grease lter properly
tted!
1. Remove the lower metal cover of the appliance by sliding the
plastic catches (Fig. 1).
2. Loosen the wire holder filtr and discard the used textile grease filtr.
3. Fit a new textile grease lter and secure it with the wire holder
(Fig. 2).
4. Attach the bottom metal cover of the appliance in the reverse
order.
Carbon lter (to be purchased)
• This lter is only used in recirculation mode.
• The lter contains activated carbon, which absorbs odors. After some time, the activated carbon saturates and
loses its absorption function.
• This lter cannot be washed or otherwise cleaned. During normal use of the appliance, the carbon lter should
be replaced every 2 months. Shorten this interval if you fry or fry more often.
1. Remove the lower metal cover of the appliance by sliding the plastic catches (Fig. 1).
2. Loosen the wire lter holder and discard the used carbon lter.
3. Install a new carbon lter and secure it with the wire lter holder.
4. In the engine compartment, "ip" the lever to recirculation mode (Fig. 3).
5. Proceed in the opposite way to replace the carbon lter.
Fig. 1
Fig. 2
Fig. 3
Engine
Paw
Paw
Engine