User manual

Keyboard operation
DVR mode
Please note that this keyboard can only control the
Concept Pro VXM4 range of DVRs
To place the keyboard in to DVR mode, press the
DVR button repeatedly until only the yellow DVR LED
is lit
MONITOR DVR
001 001
To select a particular DVR ID, press
CAM/DVR – XXX – ENTER
Where XXX is a numeric DVR ID
To select channels full screen, press XX – ENTER,
where XX is a channel number between 1 & 16.
The SEARCH, PANIC, SETUP, DISPLAY and SEQ
buttons control the relevant functions of the VXM4
To navigate through the VXM4 on screen displays (eg
during Setup and Search modes), move the joystick
up / down / left / right and press ENTER and ESC to
select or cancel items respectively.
To enter passwords (eg, during Setup and Search
modes), the keyboard must be switched to numeric
entry mode by pressing the * key
For example, when the VXM4 prompts for a
password, the following key sequence should be used
* - XXXX - * - ENTER, where XXXX is the password
Note – the * key must be pressed after the password
is entered to switch the keyboard back to normal
operation
When the VXM4 is in playback mode, the five
playback buttons and / or the joystick can be used to
control playback as follows:
Select forward play – move the joystick right or press
►
Select reverse play – move the joystick left or press
◄
Pause playback – press װ
Increase forward / decrease reverse play speed –
press ►► or twist the joystick right
Decrease forward / increase reverse play speed –
press ◄◄ or twist the joystick left
Additional operations if a matrix is connected
When a particular VXM4 ID is selected on the
keyboard, the appropriate input on the matrix is
automatically switched according to the DVR / Set
Associate programming (page 3).
When multiple monitors are connected, individual
VXM4s can be displayed on different monitors.
To select the required monitor, press
MON – XXX – ENTER
And then select the required VXM4 to be displayed
on that monitor by pressing
CAM/DVR – XXX – ENTER
Keyboard operation
DVR / AI mode
Please note that this keyboard can only control the
Concept Pro VXM4 range of DVRs.
In DVR/AI mode only individual channels can be
selected full screen. For full control of a VXM4,
the standard DVR mode should be used (see
opposite)
To place the keyboard in to DVR/AI mode, press
the DVR button repeatedly until both the yellow
DVR and green AI LEDs are lit
DVR:001 CH:01
MON:001 PTZ:001
To select a particular DVR ID, press
CAM/DVR – XXX – ENTER
Where XXX is a numeric DVR ID
To display an individual channel of the selected
DVR full screen and take control of the associated
speed dome, press XX – ENTER, where XX is a
channel number between 1 & 16.
As each channel is selected full screen, the PTZ
value automatically changes according to the DVR
/ Set Associate programming (page 3)
Full control of the associated speed dome is then
available, including programming and recalling
presets, starting groups, tours, etc.
Additional operations if a matrix is connected
When a particular VXM4 ID is selected on the
keyboard, the appropriate input on the matrix is
automatically switched according to the DVR / Set
Associate programming (page 3).
When multiple monitors are connected, individual
VXM4s can be displayed on different monitors.
To select the required monitor, press
MON – XXX – ENTER
And then select the required VXM4 to be displayed
on that monitor by pressing
CAM/DVR – XXX – ENTER
7