User manual

Programming the keyboard
To access the keyboard setup, press the MENU
key – the keyboard will prompt for a password
PASSWORD:
**********
Enter the default password of 9876543210 and
press ENTER. The setup menu is displayed
SET MATRIX:
>SET_PROTOCOL>
To navigate the menu, move the joystick up/down
pressing ENTER to select menu items or ESC to
exit menu items
Matrix setup
SET PROTOCOL
Enter the keyboard setup menu and use the
joystick to highlight SET MATRIX. The cursor
flashes next to SET_PROTOCOL
SET MATRIX:
>SET_PROTOCOL>
Press ENTER and then twist the joystick left /
right to select the required protocol. Press ENTER
to accept the new protocol setting or ESC to
discard. If using a Concept Pro matrix system, the
protocol should be set to T_VC
Matrix setup
SET BAUDRATE
Enter the keyboard setup menu and use the
joystick to highlight SET MATRIX. The cursor
flashes next to SET_PROTOCOL. Twist the
joystick right to change the display to
SET_BAUDRATE
SET MATRIX:
>SET_BAUDRATE>
Press ENTER and then twist the joystick left /
right to select the required baudrate. Press
ENTER to accept the new baudrate setting or
ESC to discard. If using a Concept Pro matrix
system, the baudrate should be set to 9600
DVR setup
SET BAUDRATE
Enter the keyboard setup menu and use the
joystick to highlight SET DVR. The cursor flashes
next to SET_BAUDRATE
SET DVR:
>SET_BAUDRATE>
Press ENTER and then twist the joystick left /
right to select the required baudrate. Press
ENTER to accept the new baudrate setting or
ESC to discard. If using a Concept Pro VXM4, the
baudrate should be set to 9600
DVR setup
SET ASSOCIATE
Enter the keyboard setup menu and use the
joystick to highlight SET DVR. The cursor flashes
next to SET_BAUDRATE. Twist the joystick right
to change the display to SET_ASSOCIATE
SET DVR:
>SET_ASSOCIATE>
Press ENTER to display the set associate ID
screen
ID:01 OUT:0001
CH:01 CAM:0001
ID:01 / OUT:0001 – If a Concept Pro matrix is
connected, these two values determine which
matrix channel (OUT) is switched for a particular
DVR (ID).
For example, if a VXM4 with an ID of 7 is
connected to matrix channel 2, set ID to 07 and
OUT to 0002
CH:01 / CAM:0001 – if PTZ devices are
connected to the DVR, these values specifiy
which PTZ ID is connected to which DVR input
channel.
For example, if a speed dome with ID 32 is
connected to DVR input 7, set CH to 07 and CAM
to 0032
Use the joystick to select the value and enter a
new value using the numeric keypad. Press
ENTER to save changes.
3