User manual
''!&'%'
PLEASE NOTE: ALL NECESSARY CONNECTIONS MUST BE MADE BEFORE APPLYING POWER TO THE VXH264!
THE VXH264 IS PRE-CONFIGURED WITH THE FOLLOWING SETTINGS:
25FPS continuous recording rate per channel at CIF (352 x 288) resolution and highest image quality.
• Time and date set to correct local time
• Audio inputs 1-4 assigned to video channels 1-4 respectively
• Telemetry devices set to PELCO-D, 2400 Baud
• Based on average image recording, the above settings will provide around 5 days recording on a 250GB drive
before the footage starts to be overwritten.
POWER
System ON/OFF
ID BUTTON
Select DVR ID
RETURN
Cancel / Deselect
Previous Screen
SETUP: Open system setup menu
Channel Selection buttons
ENTER: Apply / Select / Go to next screen
DISP: Change display screen
SEARCH: Go to search mode
PTZ: Go to PTZ menu
PANIC: Record by panic setting
KEYLOCK: Lock the keys (Remote / Front)
SEQUENCE: Change to sequence screen
ZOOM: Go to zoom mode
ARCHIVE: Go to back-up menu
* If
there are multiple DVRs used in a system, each DVR can be set with a diff
erent ID. The remote controller sets each ID per DVR. This allows
all the DVRs to be controlled with one remote controller by selecting the appropriate ID.
"*'"&''"!'% "'"!'%"%
Program each DVR accordingly to system ID (see page 26 )
Press the button, this will display “!#('” on screen.
Using the channel selection buttons, input the system ID, press “
!'%” then the “%'(%!” button
To reset the ID to factory default, press the ID button and input ID 255 and press the “!'%Kbutton followed by pressing the
“%'(%!” button.
Please note your VXH264 can be controlled via the front panel buttons, IR remote control or a USB mouse.
When a USB mouse is installed an on-screen pointer will appear. This can be used to navigate the system.
NAVIGATION BUTTONS: Used for Playback
Control, Menu Naviagtion, and PTZ/Focus
Control