User manual


%"%!
SIZE / FPS / QUALITY
To change SIZE / FPS / QUALITY settings, highlight CONTINUOUS / MOTION RECORDING and
press !'%. Ensure SIZE / FPS / QUALITY is highlighted in blue and press !'% again.
The 24 hour time bar is highlighted in yellow.
Press !'%to display the orange cursor.
The orange cursor shown represents one hour (in this case between 00:00 and 01:00). The table below
the time bar shows the recording settings for this time period.
Example: To change the recording settings between 09:00 and 18:00:
Use the (%&"%,& to move the orange cursor to the 09:00 position and press !'%.
Then use the (%&"%,& to stretch the orange cursor across to the 18:00 position.
P
ress !'%. Recording settings for the selected time period are displayed.
This setup screen allows the operator to configure scheduled and motion detection recording. There are 2
sections:
SIZE / FPS / QUALITY: Recording settings for each channel can be defined across a 24 hour period, in
blocks (for example between 09:00 and 18:00) or for each individual hour. Note that when SCHEDULE
MODE is set to WEEKLY, each day of the week can also be selected.
When any settings are changed, in the SIZE / FPS / QUALITY table the estimated recording time in
days is displayed by pressing CALCULATE.
SCHEDULE: This section determines at what times the VXH264 will record and whether it is continuous
recording or motion detection.
CONTINUOUS / MOTION SETUP