User manual


"!(%!')+
&#,
DISPLAY: SEQUENCE
Press the DISPLAY button on the status bar.
Press the sequence button. The default sequence will cycle through all 4 channels,
one by one.
Sequence setup allows the operator to define a custom sequence using either single or quad
display screens.
To add a new sequence, highlight ADD and press !'%.
Sequence title is highlighted – press !'% to bring up the virtual keyboard and key in a
name or reference number for the new sequence.
Move around the virtual keyboard using the (%&"% ,& and !'% to select a
c
haracter.
To delete a character, use
Á.
To change keyboard case and use the A/a located on the bottom right of the virtual keyboard.

To exit, press %'(%!.
Press ADD to show the SEQUENCE SET-UP SYSTEM screen. This represents the first
sequence screen that will be displayed. Select the VIEW TYPE (Single or Quad view) and
press !'%
Set SCHEDULE to ON, highlight MODIFY and press !'% to display the sequence
programming screen.
When the correct screen type is displayed use the (%&"%L,& to configure the channels
required for each portion of the quad screen.
Note: Only one instance of each channel can be displayed.