User manual
' '%,"!'%"
!!&!
Speed domes and other telemetry devices connected to the VXH264, can be fully controlled from the front
panel.
In live display mode, press the #'- button. To select a camera to control, use the !!
&'"! buttons.
When PASSWORD is set to ON only authorised users or ADMIN users can control the PTZ.
Pan and tilt movement is controlled by the (%&"%,&. Zoom is controlled by turning the &(''
*
.
SCR mode & search buttons control the focus far and near.
Press the #'- button to increase the preset number and the " button to decrease.
Press #(& to program the preset, or !'% to call an existing preset.
Press %'(%! to exit PTZ mode and return to live view.
"!$ "
Panic recording will override all standard recording settings, PANIC
record settings are configured in the recording set-up. (Page 36)
Press the (%&"%,& to hightlight the % button on the status
bar, then press !'%
Press the #! button. The top right of the display shows a red P
to indicate that the VXH264 is in panic recording mode. Press the
#! button again to return to normal recording mode.
U
se the (%&"%,& to highlight the &# button on the status
bar. Use the (%&"% ,& to select sequence and press
!'%. Each channel is shown in full screen for a set period of
time (default 5 seconds) before switching to the next channel. To
stop the sequence press any channel key.
More complex sequences can be programmed through the setup
menu. (Page 22)
Only an operator with ADMIN rights can shut down the VXH264.
Use the (%&"% ,& to select on the status bar. Press
!'%. Use the cursor key to select #"*%L" then !'%
key. You can then enter the default password ‘1234’ and press
!'%.
The VXH264 shuts down and emits two beeps to indicate that power
can be safely removed.