Product Manual

Concentric International
1901 Bell Ave., Suite 18, Des Moines, IA 50315
www.concentricintl.com
Rev. 20181228
Page 2 of 11
LA Controller
Each Kit Contains the Following Components:
• (1) Control Unit
• (1) Control unit wire harness
• (1) Wired 3-button switch
• (1) 3-button switch wire harness
• (1) Double-sided tape
• (1) Mounting hardware
Optional Accessories:
• 10’ Linear actuator cable extension harness (part no: LA-EXTHARN)
• Linear actuators 2”, 4”, 6”, 8”, 10”, 12” (actuator must have a potentiometer)
Explanation / Overview:
• This unit features 3 user defined presets that are easily programmed via the wired 3-
button switch to precisely control one linear actuator. This allows you to preset up to
3 different repeatable stops in the actuator travel. By momentarily pressing the
corresponding button on the wired 3-button switch or using your own push button
switches with the optional input wires (wires included), you can extend the actuator to
the desired preset stop point.
Operations / Programming:
To move actuator extension tube in and out:
1. Press buttons 2 & 3 at the same time to make the actuator extend.
2. Press buttons 1 & 2 at the same time to make the actuator retract.