Product Manual B

Concentric International
1901 Bell Ave., Suite 18, Des Moines, IA 50315
www.concentricintl.com
Rev. 20161111
Page 8 of 10
LA Controller
Mounting:
The control unit and the wired 3-button switch must be mounted out of the weather to avoid
moisture (they are not waterproof).
The wired 3-button switch can be mounted in a variety of ways. Below you will find some
mounting options.
Use the supplied double-sided tape to mount the
switch to any flat surface.
Use the supplied mounting bolts and support bracket
for a more secure mounting option. The support
bracket can be used as a template for marking and
drilling the mounting holes.
The rear of the switch is reversible so that the switch wire harness can exit the top or bottom
of the switch housing.
1) Remove the rear of the switch by gently separating
the front and rear halves. The front and rear halves
simply snap together and can be separated by
inserting a thin blade in between the front and rear
halves.
2) Reverse the rear of the display.
3) Snap the front and rear halves back together.