Product Manual

ManualsBrandsConcentric ManualsFarm + AcreageBlack Talon Suspension Tractor Seat — Black

512 Series Seat Assembly and Operating Instructions.docx Page 1 of 4

8-22-17

Assembly and Operation Instructions

512 Series Seat

1. Seat Assembly

a. Bottom seat cushion

i. The bottom seat cushion has one stud (circled – Figure 1) and two nutserts

(circled – Figure 1) on it that are used to mount the bottom cushion to the

seat frame (Figure 2).

ii. This mounting hardware takes a 13mm wrench or socket.

Figure 1

Figure 2

Summary of content (4 pages)

PAGE 1
Assembly and Operation Instructions 512 Series Seat 1. Seat Assembly a. Bottom seat cushion i. The bottom seat cushion has one stud (circled – Figure 1) and two nutserts (circled – Figure 1) on it that are used to mount the bottom cushion to the seat frame (Figure 2). ii. This mounting hardware takes a 13mm wrench or socket. Figure 1 512 Series Seat Assembly and Operating Instructions.
PAGE 2
b. Back seat cushion i. The back cushion has one slot (circled – Figure 3) and two nutserts (circled – Figure 3) in it that are used to mount the back cushion to the seat frame (Figure 4). ii. This mounting hardware takes a 13mm wrench or socket. iii. Slide the slot in the seat back onto the tab on the seat frame before installing the mounting screws. Figure 3 Figure 4 c. Seat frame back cover plate i. Slide the top of the back cover plate inside of the top lip of the seat frame (circled – Figure 5). ii.
PAGE 3
2. Seat frame angle adjustment a. The seat assembly can be angled back about 14° - useful if your mounting surface is angled forward. Before changing this angle, it is recommend that you first back off on the seat weight adjustment to the lightest setting before changing the seat assembly angle. To change the seat assembly angle, follow the steps listed below (see Figure 6): i. Remove the back cover from the seat frame. ii.
PAGE 4
. Seat Operation a. To adjust the seat position front-to-back i. Move the lever, that is under the front of the seat, to the left. This will release the position catch and the seat can be slid forwards and backwards. Releasing the lever will allow the lever to catch a latching position to stop the seat from sliding forwards or backwards. There is approximately 6 1/2" of slide travel available. b. To adjust the weight range of the seat i.