Specifications
Table Of Contents
- ugh015-0100.pdf
- Contents
- Introduction
- Description
- Installation
- Operation
- Maintenance
- Troubleshooting
- Before beginning
- Diagnostics
- Repair
- Checking and replacing fuses
- Resetting overloads
- Replacing the pump overload
- Replacing the motherboard
- Replacing the heater contactor
- Checking thermocouples
- Replacing thermocouples
- Repairing solenoid valves
- Replacing heater elements
- Removing the pump
- 3/4-2 Hp Pump disassembly/assembly
- 3-7.5 Hp Pump disassembly/assembly
- Appendix
- Parts/Diagrams
Set dip switch 4 to the
ON position.
Close the electrical
enclosure and restore
power to the unit.
When Auto Start is enabled:
◆ The Auto Start indicator light flashes to indicate that the
Thermolator can start at any time. The Thermolator will
start whenever the remote switching or timing device sends
a signal to start processing.
◆ The Auto Start indicator light is on whenever the
Thermolator is under the control of the remote device.
To disable Auto Start:
Repeat steps 1,2 and 7, setting dip switch 4 to the OFF instead
of the ON position.
INSTALLING THE
AUTO START
FEATURE
(TW-2 ONLY
)
UGH015/0100 Thermolator TW-1 and TW-2
INSTALLATION 3-17
6
NOTE: All dip switch illus-
trations in this manual show
switches 7 and 8 set to ON.
If you have an Isolated
Circuit model, these switch-
es should be set to OFF.
876
54
3
21
7