Specifications
Table Of Contents
- ugh015-0100.pdf
- Contents
- Introduction
- Description
- Installation
- Operation
- Maintenance
- Troubleshooting
- Before beginning
- Diagnostics
- Repair
- Checking and replacing fuses
- Resetting overloads
- Replacing the pump overload
- Replacing the motherboard
- Replacing the heater contactor
- Checking thermocouples
- Replacing thermocouples
- Repairing solenoid valves
- Replacing heater elements
- Removing the pump
- 3/4-2 Hp Pump disassembly/assembly
- 3-7.5 Hp Pump disassembly/assembly
- Appendix
- Parts/Diagrams
UGH015/0100 Thermolator TW-1 and TW-2
SELECTING THE
TEMPERATURE
CONTROL POINT
(TW-2 ONLY
)
INSTALLATION 3-13
Press the RUN button to save the control point.
◆◆
The control will display “Pr OFF” to prompt you to
remove power to the unit.
IMPORTANT: If RUN is not pressed, the new
control point source will not be saved.
Turn off power to the unit. Disconnect and lock out
the main power supply.
Open the electrical
enclosure.
Set dip switch 5 to
OFF.
Close the electrical enclosure and restore
power to the unit.
The Thermolator will now control the process temperature
based on actual temperatures recorded at the new control
point source.
8
9
10
11
876
54
3
21
12