Specifications
Table Of Contents
- ugh015-0100.pdf
- Contents
- Introduction
- Description
- Installation
- Operation
- Maintenance
- Troubleshooting
- Before beginning
- Diagnostics
- Repair
- Checking and replacing fuses
- Resetting overloads
- Replacing the pump overload
- Replacing the motherboard
- Replacing the heater contactor
- Checking thermocouples
- Replacing thermocouples
- Repairing solenoid valves
- Replacing heater elements
- Removing the pump
- 3/4-2 Hp Pump disassembly/assembly
- 3-7.5 Hp Pump disassembly/assembly
- Appendix
- Parts/Diagrams
UNPACKING THE
BOXES
Thermolator TW-1 and TW-2 UGH015/0100
3-2 INSTALLATION
Carefully remove the Thermolator and compo-
nents from their shipping containers, and set upright.
Remove all packing material, protective paper,
tape, and plastic. Check inside the electrical enclosure
and behind the side panels for accessories or hardware
that may have been placed there for shipping.
Carefully inspect all components to make sure no
damage occurred during shipping, and that you have all
the necessary hardware. If damage is found, notify the
freight company immediately.
Take a moment to record serial numbers and
specifications in the blanks provided on the back of the
User Guide’s title page. The information will be helpful if
you ever need service or parts.
You are now ready to begin installation.
Complete the preparation steps on the next page.
Remote control cord
(TW-2 only)
Thermolator
1
2
3
4
5
Thermolator TW models come fully assembled. If they were
specified at the time of the order, the optional purge valve or
motorized cooling valve is factory-installed.
Motorized cooling valve
(optional)
Compressed air mold purge
(optional)