Technical information

7Page
DD01T0213703
14.10.02
2 2. Connection and modification of board 20E00339
ASYNCHRONOUS SPEED DRIVER INTERFACE BOARD
10x5 (green)
10x6 (blue)
10x1 (yellow)
10x0 (black)
10x3 (white)
10x4 (brown)
10x2 (red)
COM
AIV
+10
+24
Li1
Li2
ATV 58
Wire to solder
Wire number : x = 1 for X axis
x = 2 for Y axis
2 3. Speed driver power supply
To replace the speed drivers powered with 230V, connect the power cables directly to L1 L2 as shown
in the electric drawing.
To replace the DANFOSS speed drivers powered with three–phased 380V or three–phased 415V , you
must install a transformer.
This transformer as well as the fuses and the fuse holders are supplied in the Kit : 40 E 707 0x
The transformer is fixed on the left of the adaptor panel supplied in the kit. The connection is as
follows:
230
L1
L2
ATV 58
380 / 415V
2 x 8A Gg
Transformer 1 kVA
RAU
2 x 6A aM
2 4. Transformer coupling
The transformer has a single–phased power supply. It has +/– 15 Volt terminals so that it can be adapted
to power voltages of 215 –> 245 V and 385 –> 415 Volts.