User guide

wait, and check again until the belt moves straight.

Belt tension.

The conveyor beltÕs length has 1% tolerance. Never tension the beltÕs adjust-

ing screws with a greater tightening torque than 5 Nm.

Maintenance

During all maintenance work on the band conveyor, both the circuit-breaker

and the main circuit-breaker must be ÒOffÓ. Alternatively, the connector must

be pulled out of the power point!

Regularly check the conveyor beltÕs wear and its position on the rollers. The

belt must not move obliquely! Adjust as necessary according to the instruc-

tions under ÒStarting - If the belt moves obliquelyÓ (see previous chapter).

Clean the belt using a light cleaning agent. Do not use any sharp objects,

strong cleaning agents or chemicals which can damage the belt.

Trouble-shooting

If the band conveyor does not start

The conveyor belt motor has an overload circuit

breaker, F3, in the distribution cabinet, which trips

if you jam or overload the conveyor belt.

This is indicated in the window (A) which then

shows an Ò0Ó.

To reset, press the ÒresetÓ button (B).

Also check the wiring diagram in chapter 9, additions

and modifications can occur.

UGG003/0398 CF Series Granulators

ACCESSORIES 49