User guide

UGG003/0398 CF Series Granulators
INTRODUCTION 1
1. Introduction
This manual applies to theCF series of Conair granulators.
Model nos. CF-810, CF-814 and CF-819 specify the size of the cutting chamber.
Supplementary designations specify:
K Ð Noise encapsulated machine
U Ð Machine with extraction fan
KU Ð Noise encapsulated machine with extraction fan
KUB Ð Noise encapsulated machine with conveyor
KUP Ð Noise encapsulated machine for sheet material/profiles
Read the Manual before installing and using the machine.
Be careful when the knives are accessible, they are sharp, and
can cause personal injury!
These Conair granulators are designed for granulating injection molded, blow
molded and extruded plastic parts and scrap.
The size and performance of the granulators are designed to suit the type of
waste material.
Approval must be obtained from Conair for granulating other products
and materials for the warranty conditions to apply.
The granulators are designed so that maintenance and cleaning can be done
quickly and easily, both routine maintenance and changing of materials.
All service must be done by trained service personnel.
This Manual contains instruction for both handling and service.
Chapter 7 contains instructions directed towards service personnel.
Chapter 11 contains accessory equipment for the machine.
Other chapters contain instructions for the operator.
The granulators are delivered with an Instruction Manual and touch-up paint.
Any modifications or conversions of the machines must be approved by Conair.
This is to prevent injuries. The machine warranty and product assurance would
otherwise be rendered void.
Please address any queries to the local Conair representative or Conair
customer service.