Specifications

A ppendix l AA-9

Mounting Method 3 (continued)

6 Place the gasket over the probe hole.

7 Place the adapter plates over the gasket and secure

them to the hopper with three 10-32 UNF screws. Make

sure the adapter plate with the threaded holes is on the

bottom, and that the slots in the adapter plates are orient-

ed in the opposite direction as shown. See drawing to

right, #7.

8 Secure the coupling to the adapter plates with the four

10-32 UNF screws.

9 Screw the fitting into the coupling.

Tighten with a wrench.

10 Make sure the probe is the correct size.

The probe should extend from just above the

top of the hopper into the hopper, with the

tip approximately in-line with the bottom

edge of the diffuser cone.

11 Push the compression sleeve into the fitting.

12 Tighten the nut over the sleeve. The compression

sleeve will crimp the tube to hold the probe in place. Be

sure to position the connector in such a way as to avoid

interference of the cable with the loader, etc. Use a

wrench to tighten the nut so that it covers the threads.

Gasket

Sleeve

Connector

Coupling

Hopper

Nut

Fitting

Adapter

plate

Threaded

adapter plate