Specifications

Mounting Method 3
1 Reference the drawings at the end of this Appendix and select the drawing
that reflects your installation. Drill the appropriate hole in the top of the hopper.
2 Drill and tap three 10-32 UNF
holes to match the screw pattern
in the adapter plates and gasket.
You can use the template in the
appendix.
3 Remove the two adapter plates from the
probe mounting assembly. Set the adapter
plates aside for use in Step 7.
4 Insert the probe and mounting assem-
bly through the door of the hopper.
5 Pull the probe and mounting
assembly through the hole in the
top of the hopper. Fold the gasket
around the probe so that it will fit
through the hole.
AA-8 l A ppendix
TIP: Stretch cloth or plastic
across the inside of the hop-
per to catch metal shavings
from the hole you will drill in
the top of the hopper.
✒
NOTE: If the angled probe is
used, the bend in the probe
must be oriented to the left of
the probe connector. The
male connector must face
directly away from the center
of the hopper.
✐
Adapter
plates
4
5
Three 10-32 UNF
holes spaced
around a 2
3
/
4
in.
(69.9 mm) diame-
ter circle
2 in. (50.8 mm)
diameter probe hole
45°
Tools for Installation:
❒ Drill and 10-32 tap
❒ Flathead screwdriver
❒ 3/4-in. wrench
❒ 7/8-in. wrench
❒ 2-in. hole saw