Specifications

Mounting Method 1

1 Insert the probe through the coupling in the top of the drying hopper.

2 Screw the fitting into the coupling. Tighten with

a wrench.

3 Make sure the probe is the correct size. The

probe should extend from just above the top of the

hopper into the hopper, with the tip approximately

in-line with the bottom edge of the diffuser cone.

4 Push the compression sleeve into the fitting.

5 Tighten the nut over the sleeve. The compression

sleeve will crimp the tube to hold the probe in

place. Be sure to position the connector in such a

way as to avoid interference of the cable with the

loader, etc. Use a wrench to tighten the nut so that

it covers the threads.

AA-6 l Appendix

Sleeve

Connector

Coupling

Tools for

Installation:

❒ 3/4-in. wrench

❒ 7/8-in. wrench

NOTE:The mounting

adapter kit will only be

included if the DM-II was

ordered as a retrofit kit.

✐

NOTE: If the angled probe is

used, the bend in the probe

must be oriented to the left

of the probe connector. The

male connector must face

directly away from the center

of the hopper.

✐