Specifications

Installing the DM-II Probe
CAUTION: Hopper surfaces may be hot. Make sure the drying hopper is empty
and has cooled to room temperature before installing the probe assembly. Failure to
do so can lead to serious injury.
The DM-II probe is inserted through a hole in the top of the drying hopper and
secured to a threaded coupling with a compression fitting. Mounting adapter plates
may be necessary.
There are three mounting methods for the probe:
l Select Mounting Method 1 if you purchased a new Conair drying hopper
equipped with a factory-installed coupling for the probe.
l Select Mounting Method 2 if you are installing the probe and coupling in a
drying hopper that has enough overhead clearance to insert the probe from the
top of the hopper.
l Select Mounting Method 3 if you are installing the probe and adapter kit on a
drying hopper that does not have enough overhead clearance to insert the probe
from the top.
Appendix l AA-5