User guide

4-46 l Operation
Configuring the Set Up 1 Folder
Selecting Modes
To select a mode for either the cutter or puller:
1
Press the appropriate mode for either the cutter or puller.
2
The selected mode will appear at the bottom of each section.
3
Press the Main tab when finished selecting modes.
See Operation Section entitled, Mode Page Descriptors - Puller/Cutter Modes
NOTE: Profile/Bubble/Taper Modes will need to be set for both the puller and cutter
sections.
See Operation Section entitled, Mode Page Descriptions - Puller Modes,
Profile/Bubble/Taper Mode and Mode Page Descriptions - Cutter Modes,
Profile/Bubble/Taper Mode.
0