User guide

Using the Faults Page

To access the Faults Page:

Press the Faults tab.

If a fault occurs the screen will flash and an alarm will sound from the touch-

screen. Some faults clear automatically, others need maintenance attention.

When a fault takes place this page indicates which drives are involved and

explains the fault. Drive programs have a check and clear routine for faults in their

start up routines. Sometimes pressing “Stop”, followed by “Start” will be enough

to clear a fault. There is also a master “Fault Resets” button on this page. By

pressing this button a fault clear signal is sent to every drive.

IMPORTANT: It is advisable to take note of any faults and diagnostic codes that are

presented.

• “Previous” and “Next” buttons are available to move through the list.

• An individual fault can be acknowledged by highlighting it with the “Previous”

and “Next” buttons followed by pressing the “Accept” button.

• “Mute” will leave faults showing but will clear the sounding alarm.

When all faults are cleared the sounder is silenced.

NOTE: Diagnostics charac-

ters on the drives may be

viewed through the door

window of the lower electri-

cal cabinet. The IO Page also

shows diagnostic charac-

ters.

NOTE: The panel has the

ability to record faults to the

compact flash memory card.

Currently, this feature is dis-

abled. Contact a Conair

Representative if you a need

for this feature.

4-40 l Operation