User guide

Configuring the Network Settings

The Medline Combination Puller/Cutter’s touch panel has Ethernet capabilities.

For the Ethernet to function correctly the control must be set to conform to the

current network. The control must be rebooted for new settings to take effect. This

can be achieved by cycling the power on the control or by pressing the “Update”

button.

To setup or update the Network Settings:

1 Press the setting to be configured or updated. (IP Address, Subnet Mask, IP

Gateway or Mac ID)

2 A pop-up keyboard will appear, enter in the required setting and press

“Enter”. The keyboard will be removed.

3 Press the “Update” button to use the new settings.

The “Update” button reboots the panel. A warning is given to ensure the operator

is fully aware of what is about to happen.

The options are to “Reboot” or “Exit”. An interruption to the program happens

during the reboot. DO NOT REBOOT WHILE THE MACHINE IS RUN

NING. Network configuration is typically done only once.

Operation l 4-37

Operation