User guide

Configuring the Batch Settings
(Optional)
Set (continued)
To enter a Set amount:
1 Press the Set window. A numeric pop-up keyboard appears.
2 Key in the new set amount.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The new set amount will appear in the Set window and will then be active.
Warn
The Warn preset is set to a value less than the Batch setpoint. This level activates
an operator warning that signifies a batch is near to completion. A yellow Warn
light is shown on the touch panel when the count is between Warn and Set values.
In addition, an output is available that can be used to operate an alarm (or tower
light). In this example, Warn is off during counts 0 to 14, it activates at count 15
and deactivates at 20 (count resets to zero, Warn alarm automatically clears). If the
Warn preset is higher than the Set amount it will be disabled.
To set the Warn amount:
1 Press the Warn window. A numeric pop-up keyboard appears.
2 Key in the new warn amount.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The new warn amount will appear in the Warn window and will then be
active.
Operation l 4-27
4
Operation