User guide

Using 180 Degree Cutting (Optional)

An option is available for use with the Encoder Mode where 2 blades may be fit-

ted to the blade arm. The cut then makes 180-degree on-demand indexes (half a

revolution). 180 and 360-degree buttons are provided when this option has been

added.

Configuring the Blow Off Settings

(Optional)

A dedicated output is available for use with a Blow Off/Take Off Conveyor. This

output is intended to operate a valve to blow good pieces from the Take Off

Conveyor after they have been cut.

Offset

An offset preset length is available that acts as a delay from the cut. Distance

information is provided by the puller - not the Take Off/Blow Off Conveyor.

There is no distance information feedback available from the conveyor. In most

instances, the conveyor is set to travel faster than the puller in order to create piece

separation. This speed relationship will need to be factored in when setting the

Offset amount.

To adjust Offset amount:

1 Press the Offset window. A numeric pop-up keyboard appears.

2 Key in the new amount of offset amount, taking into account the

Take Off/Blow Off Conveyor’s speed and the puller speed.

3 Then press “Enter”. The pop-up keyboard is removed.

4 The new offset amount will appear in the Offset window.

Operation l 4-21

Operation