User guide

Using the Cutter Control

Using Encoder Sequence, Cuff and

Profile/Bubble/Taper Modes

Encoder Sequence, Cuff and Profile/Bubble/Taper Modes have many length pre-

sets. There are too many to be able to show on the Main Page. The length section

on the Main Page for these modes is replaced by a button that is used to go to a

secondary page that contains the extra presets.

Sample of the Main Page with Profile/Bubble/Taper Mode selected.

NOTE: Above is the button that is shown is for Profile/Bubble/Taper Mode. Encoder

Sequence Mode has a button labeled "Sequence Settings" and Cuff Mode has a button

labeled "Cuff Settings".

See Operation Section entitled, Mode Page Description and

Profile/Bubble/Taper Page Description, Encoder Sequence Page Description and Cuff

Page Description.

4-18 l Operation