User guide

Storing the Belt Gap

The belt gap dimension can be stored here. The value should be read from the belt

gap gauge and entered at this window. When returning to a product that was pre-

viously produced the user can recall the recipe value by viewing the saved file and

then setting the belt gap to match.

See Operation Section entitled, Using Files

Pages, File Pages.

To set the belt gap from the digital readout:

1 View the belt gap measurement from the digital readout located on the

Medline Combination Puller/Cutter’s cabinet.

2 Press the window showing the puller belt gap. A pop-up keyboard appears.

3 Enter in your new value on the pop-up key pad.

4 Press the “Enter” button to lock in the new puller belt gap. The pop-up key

board is removed.

To set the belt gap from the file recipe:

1 Open the file page that contains the desired product recipe.

2 Locate the belt gap distance within the save file page.

3 Match the digital belt gap readout on the puller/cutter’s cabinet to the

amount from the saved file page recipe using the manual hand wheel located

on the puller.

4 Enter the belt gap measurement in the Belt Gap window, by following the

following the “Setting the belt gap from the digital readout” steps.

Operation

Operation l 4-13