User guide

Using the Puller Control (continued)

Using Footage

The middle section of the puller control displays footage. Footage can be reset at

the beginning of a production run and can be used to record the amount of materi-

al produced.

To reset the footage counter:

1 Press the “Reset” button to “zero” the counter.

Using Remote Scrolling

The speed of the puller can be changed by remote control. For example, an auto-

mated diameter gauge could alter the puller speed in order to maintain diameter.

Raise and Lower inputs are available for remote operation. A simple three-wire

integration is required. LEDs show the input condition at the Raise and Lower ter-

minals. Green means the input is active, Gray means the input is off.

Remote Scroll amount is a user preference.

See Operation Section entitled, Scroll

Page Description.

The “On/Off” button is used to enable or disable the remote. The light next to this

button illuminates when Remote Scroll is on.

NOTE: If the remote gauge

is fitted with a manual

and automatic selector

then the remote option at

the puller can be perma-

nently enabled.

Operation l 4-11

Operation