User guide

Using the Puller Control

Setting the Puller Speed (continued)

A title appears at the top of the pop-up keyboard to confirm which preset is being

modified.

See Operation Section entitled, Using the Cutter Control, Setting the

Cut Length

. The explanation given in that section applies to changing any preset.

• If the pop-up is accessed by mistake press “Exit” to remove it. Also, if an incor-

rect value is entered press “Exit” to retain previous value.

• “Raise” and “Lower” buttons will add or subtract one least significant digit,

i.e. for two decimal places the value will change by 0.01, for three decimal

places the value will change by 0.001.

• “Prev” and “Next” buttons are used to go to the next preset on the page. If

there is only one preset on the page the preset will remain selected.

• The (+/-) key should not be used - all values are positive. All presets are range

checked, a negative value will be ignored.

All numeric presets use the same style numeric keyboard. A computer style key-

board appears for text presets, i.e. user or filename entry.

4-10 l Operation

NOTE: In this example, cut

length is being altered.

The procedure to change

any measurement using

the Keyboard method is

exactly the same.