User guide

Using the Puller Control

Setting the Puller Speed (continued)

Scroll Method

The (+) and (-) buttons can be used to add or subtract the value shown in the

Scroll Size window to the current speed setting. Scroll Size is a user preference

value. Four presets are available but only one may be selected at any given time.

In the example, the chosen Scroll Size is set to ±0.10 FPM.

To enter a new puller speed:

1 Press either the (+) or (-) scroll button to increase or decrease the set

speed. For example, 40 FPM becomes 40.10 FPM after pressing (+) once. The

(-) button will subtract 0.10 FPM from the current set speed - example 40 FPM

becomes 39.90 FPM after pressing (-) once.

Typically, the operator will choose four values from fine to coarse that would be

used for control of the line. An example is 0.01, 0.10, 1.00 and 5.00 FPM.

Pressing the Scroll Size window will toggle through the four preset increments.

Keyboard Method

To enter a new puller speed:

1 Press the window showing the puller speed. A pop-up keyboard appears.

2 Enter in your new value on the pop-up key pad.

3 Press the “Enter” button to lock in the new puller speed. The pop-up key

board is removed.

(continued)

Operation l 4-9

Operation

NOTE: To set new scroll

increments,

see Operation

Section entitled, Scroll

Page Description.

NOTE: In this example, cut

length is being altered.

The procedure to change

any measurement using

the Keyboard method is

exactly the same.