User guide

Using the Puller Control
For right-to-left configurations the cutter control is shown on the left with the
puller control on the right, as in the example. Images of the controls may be
switched at the factory for left-to-right combinations.
A message appears above each control to show if the drive is running or stopped.
"Running" is shown as white text on a green background and "Stopped" is shown
as white text on a red background. The cutter cannot run alone - it is interlocked
with the puller, meaning that the puller must be running before the cutter can run.
Likewise, if the puller is stopped the cutter will stop.
Setting the Puller Speed
Speed Control
The Main Page is used to view and set speed. Speed may be changed by using the
(+) and (-) buttons that are just below the speed readout (Scroll Method) or they
may be keyed in using a pop-up keyboard (Keyboard Method).
IMPORTANT: For Profile/Bubble/Taper products speed is controlled by a different
program, it cannot be changed here.
4-8 l Operation
(continued)