User guide

Installation

Installation l 3-13

Setting the Belt Gap

For Puller Model CPC 1-12

The upper and lower belt boom assemblies are controlled by a common threaded

rod. Turn the hand wheel to move the belts up and down. The belt gap should be

set to the dimensions of the extruded product, being careful not to make the gap so

small that the pressure causes distortion in the product.

1 Turn the hand wheel until the gap between the belts reaches the desired dis-

tance.

For Puller Model CPC 3-20

The upper and lower belt boom assemblies are controlled

by a common threaded rod. The upper and lower belts

move away from each other or toward each other as the

hand wheel is turned. The belt gap should be set to the

dimensions of the extruded product, being careful not to

make the gap so small that the pressure causes distortion

in the product.

1 Turn the hand wheel until the gap between the belts

reaches the desired distance.

Hand wheel