User guide

3-10 l Installation
Adjusting Belt Tension
For Puller Model CPC 1-12
1 Turn the main power disconnect to the off position.
2 Remove the upper and lower polycarbonate belt guards:
• Remove the screws attaching guards to unit (five each: front).
• Remove guards.
3 Check belt tension. Use a tension-measuring tool. Belts should be just tight
enough to prevent slipping, and the gap between the upper and lower belts
should be even across the width of the belt.
4 Adjust belt tension, if necessary.
Adjust tension by turning the threaded tension rods. Keep tension on front and
back edges, the top and bottom belts should be as even as possible.
0
NOTE: Loose belts result in
belt and product slippage;
over-tightened belts result in
distorted product and can
lead to premature bearing
failure.
Threaded tension rods
Screw (10)
(continued)