User guide

3
Installation
Installation l 3-9
Mounting the Cutter Bushings
(continued)
4 Slide the upstream bushing into position, positioning it up to and barely
touching the blade (using a feeler gauge). NOTE: the blade should not be
deflected.
5 Tighten the bushing retaining system against the flat side of the bushing to
hold the bushing in position.
6 Rotate the cutter head by hand to make sure the bushings did not move, and
that the blade still passes through the gap between the bushings.
DANGER: Sharp blades
Always wear cut-resistant gloves when the cutting chamber is open and when
handling blades. Never open cutting chamber without locking out the cutter
power and waiting until the cutter head stops spinning.