User guide

3-8 l Installation

Mounting the Cutter Bushings

1 Rotate the cutter head until the blade is positioned in the gap between where

the bushings are located.

2 Slide the downstream bushing into position, positioning it up to and barely

touching the blade (using a feeler gauge). NOTE: the blade should not be

deflected.

3 Tighten the bushing retaining system against the flat side of the bushing to

hold the bushing in position.

DANGER: Sharp blades

Always wear cut-resistant gloves when the cutting chamber is open and when

handling blades. Never open cutting chamber without locking out the cutter

power and waiting until the cutter head stops spinning.

NOTE: For more infor-

mation about setting

and adjusting the gap

for the bushings,

see

Appendix C, About

Cutter Bushings

Bushing Retaining System

(continued)