User guide

3-6 l Installation

Connecting the Main Power Source

1 Open the combination puller/cutter’s electrical enclosure. Turn the discon-

nect dial on the door to the OFF or “O” position and open the door.

2 Insert the main power wire through the knockout in the side of the enclosure.

Secure the wire with an appropriate strain relief.

3 Connect the power wires to the terminals indicated on the wiring diagram that

came with your machine.

4 Check every terminal screw to make sure

wires are secure. Gently tug each wire. If a

wire is loose, use a screwdriver to tighten the

terminal.

5 Connect the ground wire to the grounding

point shown in the wiring diagram shipped

with your unit.

WARNING: Electrical hazard

Before performing maintenance or repairs on this product, disconnect and

lock out electrical power sources to prevent injury from unexpected energiza-

tion or start-up. A lockable device has been provided to isolate this product

from potentially hazardous electricity.

WARNING: Improper installation, operation, or

servicing may result in equipment damage or

personal injury.

This equipment should only be installed, adjusted, and serviced by qualified

technical personnel who are familiar with the construction, operation, and

potential hazards of this type of machine.

All wiring, disconnects, and fuses should be installed by qualified electrical

technicians in accordance with electrical codes in your region. Always main-

tain a safe ground. Do not operate the equipment at power levels other than

what is specified on the machine serial tag and data plate.

IMPORTANT: Always refer to

the wiring diagrams that came

with your combination

puller/cutter before making

electrical connections. The

diagrams show the minimum

size main power cable

required for your machine, and

the most accurate electrical

component information.