User guide

Installation l 3-5
Positioning the Medline
Combination Puller/Cutter
(continued)
3 Measure the centerline height of the extrudate as it exits the extrusion die.
Adjust all equipment on the extrusion line (sizing tank, cooling tanks,
puller/cutter) to this height.
4 Adjust the puller/cutter's floor lock/caster assembly to the center height of
the extrusion line using a 16 or 18-inch adjustable wrench. Remove the weight
from the casters by locking down the floor locks.
IMPORTANT: Never leave the puller/cutter on casters only.
5 Use a plumb line or laser to check for a straight line from the extrusion die
through each line component to the cutter bushings. Adjust as necessary.
6 Adjust the belt puller entrance guide rollers to insure consistent product
guidance.
3
Installation