User guide

2-10 l Description

Cutter Optional Equipment (continued)

• Follower cutting Mode - Follower Mode allows the operator to program the

desired cut length and the number of blades. The controller then automatically

follows the puller and adjusts the speed of the flywheel to maintain cut length

accuracy. This is known as an electronic gear lock system. The cut length accura-

cy is maintained even if the puller changes speed.

Common Optional Equipment

• Discharge conveyor - A discharge conveyor offers support before, during, and

after cutting, and facilitates the removal of cut parts. Discharge conveyors are

available in the following sizes:

• 6 inches wide by 6 feet long

• 6 inches wide by 12 feet long

• 6 inches wide by 16 feet long

• Isolation Transformer - The isolation transformer protects sensitive electronics

from incoming power, which helps prevent errors caused by electrical noise. It

also protects equipment from electrical noise generated by the servo motor and

associated amplifiers.

• Left-to-Right machine operation - This option changes the machine direction .

from the standard right-to-left extrusion flow to left-to-right.

Your Conair sales representative can analyze your needs and recommend the

options that are right for your system.

NOTE: Conair strongly recommends using an isolation transformer. Ensuring clean and proper

power can help avoid the need for costly service calls.

NOTE: An isolation transformer will not compensate for a ground that does not meet code

requirements.