User guide

Puller Optional Equipment

• Digital belt gap sensor and readout - (Optional) Allows the operator to set a

zero point, then measure belt gap (in thousandths of an inch) relative to this

setpoint.

• Remote belt speed control - (Optional) Allows the puller speed to be controlled

by an external source. (Remote Digital Potentiometer)

• In-line planetary gear reducer ratios - A particular reducer ratio is selected at

the time of purchase to optimize puller performance in a particular speed range.

Contact a Conair Representative for application specific gear reducers

Cutter Optional Equipment

• Cutter bushing lubrication - (Optional) A self-contained spray system, which

includes a reservoir and an air inlet for operation at 20-30 psi (air source not

included). A flexible nozzle directs lubricant onto the extrudate as it enters the

cutter bushings. This decreases bushing drag and helps lubricate the blade. This

option is recommended for processing sticky/soft (low durometer) materials.

• Cutter blade wipe - (Optional) Keeps the cutting blade clean by removing

lubricant and particles. A reservoir chamber with a flexible drip tube feeds

lubricant to a felt pad sandwiched between two pieces of stainless steel in the

particulate tray. The pad wipes and lubricates the knife before each cut.

• Profile/Bubble/ Taper software upgrade package - The standard serial operator

interface units are replaced with a common color touchscreen operator interface.

A positional control unit is added to the puller servo drive, along with a PLC

(Programmable Logic Controller) enabling positional moves needed for

Profile/Bubble/Taper tubing processing. Basic output package enables operation

for up to two lumens with 32 points of analog outputs each. Specialized soft-

ware for processing Profile/Bubble/Taper tubing includes: up to 32 preset position-

al moves for input speed and distance, 24 VDC output for blow off, four digital

powered outputs - 24 VDC transistorized 0.25 amps each and two 0 to 10 VDC

analog outputs.

• Main cabinet housing - (Optional) Stainless steel in place of standard white

painted carbon steel cabinet.

Description l 2-9

Description

(continued)