User guide

Troubleshooting l 6-17
6
Troubleshooting
Checking the Encoder
When the encoder is working properly, the measurement displayed will count up to
the preset and reset to zero.
1 Check all connections.
2 Check the encoder cable for damage. If necessary, replace.
3 Check the connector that attaches the cable to the encoder. Internal wiring
may be shorted out if this connector is not handled properly.
4 Check the encoder itself. There should be no play in the shaft.
5 If all else fails, contact Conair Customer Service. See Appendix A.
WARNING: Delicate equipment
THe encoder is a delicate piece of equipment. Any rough handling can
damage fragile parts.