User guide

Maintenance l 5-11

Checking Electrical Connections

1 Be sure the main power is disconnected and the cutter is locked out.

Always disconnect and lock out the main power source before opening the unit

or servicing.

2 Turn the main power disconnect to the off position before opening the elec-

trical enclosure on the back of the cutter, or the back of the control. This is a

safety device to prevent you from opening the doors if the power is still on.

Maintenance

WARNING: Improper Installation, operation, or

servicing may result in equipment damage or

personal injury.

This equipment should only be installed, adjusted, and serviced by qualified

technical personnel who are familiar with the construction, operation, and

potential hazards of this type of machine.

All wiring, disconnects, and fuses should be installed by qualified electrical

technicians in accordance with electrical codes in your region. Always maintain

a safe ground. Do not operate the equipment at power levels other than what is

specified on the machine serial tag and data plate.

WARNING: Electrical Hazard

Before performing any work on this product, disconnect and lock out electri-

cal power sources to prevent injury from unexpected energization or start-

up. A lockable device has been provided to isolate this product from poten-

tially hazardous electricity.

Main Power

Safety

Disconnect

(continued)