User guide

5-10 l Maintenance
Adjusting the Cutter Proximity
Switches
Follow all warnings and cautions listed at the beginning of the Maintenance sec-
tion of this User Guide.
1 Be sure the main power is disconnected and the cutter is locked out.
2 Loosen the bushing retaining
system that holds the cutter
bushings.
3 Remove the cutter bushings.
4 Check the depth of the proximity switch face for each bushing. It should be
recessed no more than 0.010 inches, but should not interfere with the bushings
themselves.
5 Use a wrench to check the tightness of each proximity switch
6 Replace cutter bushings and check for proper cutting blade alignment. See
Installation Section entitled, Mounting the Cutter Bushings and Appendix C
and D.
7 Plug in the power cord and turn the main power disconnect to the “ON” posi-
tion if all other maintenance is completed.
NOTE: You can damage the proximity switch if you over-tighten
0
Bushing Retaining
System
Proximity
Switch