User guide

5-8 l Maintenance
Cleaning Particulate Trap
The Particulate Trap is built into the cutter assembly. Depending on cut rate and
type of material and lubrication, the area will need to be cleaned on a regular basis.
Open the knife guard and, using a shop vac or other similar equipment, remove all
liquid and solids from the cutting chamber and around the bushings.
Lubricating the Linear Rail
Check the shafts on the linear rail system. Even though these rails are stainless
steel, it is recommended that a light oil (WD-40 or similar) be applied to the shafts
as needed. Wipe off any excess.
Particulate Trap
Linear Rail