User guide

Stopping Only the Cutter

You can shut down just the cutter portion of the combination puller/cutter if you

need to change or adjust cutter blades:

1 Press Cut On/Off Softkey to Off to stop cutting.

2 Press Stop Cutter button to disable the servo motor.

3 Turn Cutter Power On/Off switch to Off. Power is no longer supplied to the

cutter portion of the combination puller/cutter. The belt puller will continue

running.

See Installation Section entitled, Installation Cutter Blades.

Operation l 4-177

Operation

NOTE: Press the “Cutter Off” button if using Red Lion HMI and Control Techniques/

Emerson Servo Drives