User guide

Operation

Operation l 4-169

Start-Up Preparations for Puller

If you have not already done so, perform daily maintenance check, power up the

puller/cutter, select the cutting mode and blade speed and make a test cut to check

cut quality.

Use the slide system to move the cutter as far from the puller as possible:

1 Loosen the turnbuckle below the puller/cutter by turning 1-2 turns clockwise.

2 Slide the cutter as far downstream as it will go.

3 Tighten the turnbuckle by turning it counterclockwise.

1 Locate puller on the extrusion line with the floor support pads adjusted to the

product centerline.

2 Be sure power supply matches specified belt puller power before connecting.

If unsure, please do not hesitate to call for service.

3 Adjust the belt puller entrance guide rolls to insure consistent product guid-

ance.

4 Adjust the belt opening to allow consistent traction to the product without

deformation.

WARNING: Improper Installation, operation, or

servicing may result in Equipment damage or

personal injury.

This equipment should only be installed, adjusted, and serviced by qualified

technical personnel who are familiar with the construction, operation, and

potential hazards of this type of machine.

All wiring, disconnects, and fuses should be installed by qualified electrical

technicians in accordance with electrical codes in your region. Always maintain

a safe ground. Do not operate the equipment at power levels other than what is

specified on the machine serial tag and data plate.

NOTE: Never operate belt puller on casters only.

(continued)