User guide

Puller Operator Control Instructions:
Using Scroll Increments
Lg (Course) and Sm (Fine) puller scroll increments are used to adjust the puller’s
speed (FPM). Each preset is programmed to increase or decease the puller’s speed by
a user specified amount. Rm (Remote) can only be used with the optional Puller
Speed Remote.
See Operation Section entitled, Puller Operator Control Instructions,
Puller Speed Remote.
To adjust the puller’s speed using scroll increment presets:
1
Press the Scroll Increment Softkey/Softkey 1 to toggle through the types of
scroll increments. Typically, the Lg (Course) setting is used when starting an
extrusion line, while Sm (Fine) is used to fine-tune the puller speed.
2
Use the “Raise” and “Lower” buttons to increase or decrease the puller speed
by the increment selected. (Lg, Sm)
SPEED 500.0 FPM
Lg. Change Ftg.
4
Operation
Operation l 4-163