User guide

Puller Operator Control Features
The Operator Control provides an intuitive user-friendly method to interface with
the Conair Servo Puller. Information is viewed and entered at the Operator Control
and is communicated to the servo positional amplifier via the RS-232 serial com-
munication link.
The Operator Control is a flat membrane panel consisting of 22-keys and a large 2
line x 20 back lit LCD screen.
Soft Keys
Soft keys - these are the three keys directly under the display. All three have a tri-
angle on them. Occasionally, pages will appear that allow the operator to use one
of the soft keys. On those occasions, text would typically appear directly above the
key and the key will have a function. Think of the text as the soft key function
indicator or title. These keys will be referred to in this manual from left to right as
soft keys 1, 2 and 3 respectively.
Numeric Keys
These are the black keys containing numbers 0 to 9. Numbers permit data entry of
parameters. See Raise and Lower for value trim.
Fixed Function Keys (at Bottom)
Underneath the numeric keys are fixed function keys. They contain universal sym-
bols and text. The fixed function keys are Raise, Lower, Next, Prev (previous),
Enter, Delete, Exit, Menu and Mute. These functions are described in the
"Function keys - Fixed Functions" section of this manual.
LCD Screen
The screen shows various pages depending on operator actions. In addition, it is
used to indicate warnings. Mostly, it is used for viewing status and for setting
parameters.
Soft Keys-allows the
operator to select dif-
ferent functions.
Numeric Keys-
Permits data entry for
the operator
Fixed Function Keys-
Contain universal
symbols & text
4-160 l Operation